Set Up SNMP V1 and V2c Notification Destination

To configure the notification destination (trap/inform receiver) for V1/V2c, perform the following procedure.

Procedure

Step 1

Select Snmp > V1/V2c > Notification Destination.

Step 2

Select the required server from the Server list box, and then click Find.

Step 3

Perform one of the following tasks:

To add a new SNMP notification destination, click Add New.

You configure the notification destination for the server that you choose in the Server drop-down list box in the Find/List window.

Note

The Add New button does not display in the SNMP Notification Destination Configuration window until you select the Find button. If no notification destinations exist and you want to add a notification destination, select Find and then wait for the window to refresh. The Add New button displays.

To modify an existing SNMP notification destination, find the notification destination that you want to edit, and then click the name of the SNMP notification destination in the Find/List window results list.

Step 4

Enter the notification destination configuration settings.

Tip

Before you save the configuration, you can click the Clear button at any time to delete all information that you entered for all settings in the window.

Step 5

Perform one of the following actions:

Select Insert to save a notification destination.
Select Save to save changes to an existing notification destination. A message indicates that changes will not take effect until you restart the SNMP master agent.

Step 6

Select OK to restart the SNMP master agent or select Cancel to continue the configuration without restarting the SNMP master agent.

Note

Cisco recommends that you wait until you finish the SNMP configuration before you restart the SNMP master agent service.