Set Up SNMP Traps

To set up SNMP traps, perform the following steps.

Procedure
    Step 1   Login to Cisco Unified Serviceability and confirm that Cisco CallManager SNMP Services and SNMP Master Agent are activated and running by performing the following steps:
    1. Choose Tools > Control Center - Feature Services and confirm that Cisco CallManager SNMP Services is started.
    2. Choose Tools > Control Center - Network Services and confirm that SNMP Master Agent is started.
    Step 2   If you want to run SNMP V1 or V2, confirm that the community string and notification destination is set up by performing the following steps:
    1. Follow the Set up community string procedure and make sure that Access Privileges are set to either ReadWriteNotify, NotifyOnly, or ReadNotify.
    2. Follow the Set up notification destination procedure.
    Step 3   If you want to run SNMP V3, confirm that the user and notification destination is set up by performing the following steps:
    1. Follow the Setup SNMP user procedure and make sure that Access Privileges are set to either ReadWriteNotify, NotifyOnly, or ReadNotify.
    2. Follow the Set up notification destination procedure.
    Step 4   Login to CLI and run the utils snmp test CLI command to verify that SNMP is running.
    Step 5   Follow Generate SNMP traps to generate specific SNMP traps (for example, the ccmPhoneFailed or MediaResourceListExhausted traps).
    Step 6   If the traps do not generate, perform the following steps:
    • In Cisco Unified Serviceability, choose Alarm > Configuration and select CM Services and Cisco CallManager.
    • Check the Apply to All Nodes check box.
    • Under Local Syslogs, set the Alarm Event Level drop-down list box to Informational.
    Step 7   Reproduce the traps and check if the corresponding alarm is logged in CiscoSyslog file.